12Vdc的荧光灯驱动电路-12VDCFluorescentLampDriver

12Vdc的荧光灯驱动电路-12VDC Fluorescent Lamp Driver
  A number of people have been unable to find the transformer needed for the Black Light project, so I looked around to see if I could find a fluorescent lamp driver that does not require any special components. I finally found border=0>
  
  Parts:
  Part
   Total Qty.
   Description
   Substitutions
   
  C1
   1
   100uf 25V Electrolyt Capacitor
   
   
  C2,C3
   2
   0.01uf 25V Ceramic Disc Capacitor
   
   
  C4
   1
   0.01uf 1KV Ceramic Disc Capacitor
   
   
  R1
   1
   1K 1/4W Resistor
   
   
  R2
   1
   2.7K 1/4W Resistor
   
   
  Q1
   1
   IRF510 MOSFET
   
   
  U1
   1
   TLC555 Timer IC
   
   
  T1
   1
   6V 300mA Transformer
   
   
  LAMP
   1
   4W Fluorescent Lamp
   
   
  MISC
   1
   Board, Wire, Heatsink For Q1
   
   Notes:
  1. Q1 must be installed on a heat sink.
  2. A 240V to 10V transformer will work better then the one in the parts list. The problem is that they are hard to find.
  3. This circuit can give a nasty (but not too dangerous) shock. Be careful around the output leads.