找回密码
 注册会员
更新自动建库工具PCB Footprint Expert 2024.04 Pro / Library Expert 破解版

[基础电路] 水位告警器

[复制链接]
admin 发表于 2013-2-20 23:35:13 | 显示全部楼层 |阅读模式

本文包含原理图、PCB、源代码、封装库、中英文PDF等资源

您需要 登录 才可以下载或查看,没有账号?注册会员

×
ET423302010080918240512011060817364411988.jpg This circuit not only indicates the amount of water present in the overhead tank but also gives an alARM when the tank is full.
  The circuit uses the widely available CD4066, bilateral switch CMOS IC to indicate the water level through LEDs.
  When the water is empty the wires in the tank are open circuited and the 180K resistors pulls the switch low hence opening the switch and LEDs are OFF. As the water starts filling up, first the wire in the tank connected to S1 and the + supply are shorted by water. This closes the switch S1 and turns the LED1 ON. As the water continues to fill the tank, the LEDs2 , 3 and 4 light up gradually.
  The no. of levels of indication can be increased to 8 if 2 CD4066 ICs are used in a similar fashion.
  When the water is full, the base of the transistor BC148 is pulled high by the water and this saturates the transistor, turning the buzzer ON. The SPST switch has to be opened to turn the buzzer OFF.
  Remember to turn the switch ON while pumping water otherwise the buzzer will not sound!
*滑块验证:
您需要登录后才可以回帖 登录 | 注册会员

本版积分规则

QQ|手机版|MCU资讯论坛 ( 京ICP备18035221号-2 )|网站地图

GMT+8, 2024-12-23 19:17 , Processed in 0.066936 second(s), 13 queries , Redis On.

Powered by Discuz! X3.5

© 2001-2024 Discuz! Team.

快速回复 返回顶部 返回列表